Jump to content

Fitting Powrtouch Rollers


BJH
 Share

Recommended Posts

Brilliant service from Powrtouch again - free replacement rolloers although I'm out of guarantee. But. ......

 

Now I have to fit them!

 

It's a model 3 heavyy duty version and I think I have to disconnect some of the gearing on the inside of the roller housing ?

 

Has anyone done this? Any tips??

 

Thanks

 

Brian

Link to comment
Share on other sites

The others usually pull off after undoing the 3 bolts that you can see. , If it's different, phone powrtouch and they will help you.

Regards Peter :)

Link to comment
Share on other sites

  • 3 weeks later...

sometime ago I refurbished my old Mk2 and stripped the entire gearbox and rollers. you need to remove the screws holding the outer end plate and then the rear gearbox casing, you will need an allen key to remove the centre screw and remove the gear cog. You should then be able to lightly tap the roller C/W bearings, refit is reversal, but ensure you pack the gearbox with grease. give yourself about an hour each side.

Link to comment
Share on other sites

 Share

×
×
  • Create New...