Jump to content
Sign in to follow this  
mark-swans

Reich Move Control Roller Replacment Help

Recommended Posts

hi

would anybody know how to replace the rollers on my reich single axle move control ??? i see there is a 6mm allen key at one end ?

many thanks mark

Share this post


Link to post
Share on other sites

Hi Mark. To replace the rollers, all you have to do is remove the three bolts on each drive motor, disconnect the wiring to each motor (which are push on/pull off spade fittings), and then pull each motor and drive-shaft towards the centre line, and the whole thing comes away in one piece (each side separately). Once removed, the shaft just pulls away from the motor.

Edited by Eddie

Share this post


Link to post
Share on other sites

Hi Mark,

When you have the rollers off be sure to check that the drive pins are central to the shafts.

Cheers Robbie

Share this post


Link to post
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Guest
Reply to this topic...

×   Pasted as rich text.   Restore formatting

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

Sign in to follow this  

×
×
  • Create New...