Jump to content
Sign in to follow this  
Wulfie

Motor mover PCB

Recommended Posts

Posted (edited)

Hi Guys would anyone on here know where I can get a PCB unit as mine has decided that it has died. The remote unit still works with the PCB but when I checked it the red light was flashing 7 times then a pause then repeated. Switched of the unit and then switched the unit on after a few minutes. The red light the flashed for 3 times and repeated. This said that there wads a chasis short fault. Checked and made sure there was a very good connection. Switched on the unit again to get the same problem. Found a flow chart to try to find out what was happening and the result was that I have a faulty PCB. The unit is a truma althoth it says carver on the remote unit.

So, is there anyone out there that knows where I can get one cheap as I am on very limited budget, or someone that can repair it for me.

 

Thanks for your time

Colin

Edited by Wulfie

Share this post


Link to post
Share on other sites

They do, depending upon model, come up on eBay now and then.

 

I sold a used Reich 4WD PCB on eBay recently.

 

Went for a fraction the cost of a new one.

Share this post


Link to post
Share on other sites

They are good people - I took my circuit board and controller in a few years ago. They diagnosed a dry solder joint in minutes and fixed it FOC.

Share this post


Link to post
Share on other sites
Sign in to follow this  



×
×
  • Create New...