Jump to content

Levellers


jjohnd
 Share

Recommended Posts

Can somebody please explain how an Al-Ko wheel lock is fitted in conjunction with the Milenco wheel leveller?

Link to comment
Share on other sites

I don't own one but I assume it is just a case of putting your van on the pitch and then move forwards/backwards with a mover or tow car to align the lock. Then use the Milenco leveller to raise the low side of the caravan. There are other similar products on the market (like Lock n Level) which allow you to raise the van after the lock is fitted thus avoiding the issue of trying to level the caravan and align the lock on wedge shaped ramps.

 

Personally I use plastic Lego type blocks which stack together to form a stepped but flat surface. That allows you to raise the van to the right level and then move backwards and forwards at that level to align the lock. Blocks of wood can do the same thing.

 

Someone who owns the Milenco leveller may be able to provide more specific instructions if this doesn't clarify it.

 

Mark.

Edited by Markt1891
Link to comment
Share on other sites

i had one off these levelers and found it next to useless,the ratchet supplied with it slipped and became unusable and the

lifter section wedged itself onto the tyre and became quite difficult to take off, the leveler was returned to the dealer after one use

and i recieved a full refund,which was good. ...

Link to comment
Share on other sites

You simply fit the wheel lock and then the leveller. Much simpler process than using ramps.

 

Unlike the previous poster I have used a Milenco leveller successfully for years and have not had any problems with it.

 

Bob

Link to comment
Share on other sites

i had one off these levelers and found it next to useless,the ratchet supplied with it slipped and became unusable and the

lifter section wedged itself onto the tyre and became quite difficult to take off, the leveler was returned to the dealer after one use

and i recieved a full refund,which was good. ...

My experience as well. as far as using them with the wheel lock I agree with Bob,

Regards,

Ian.

Link to comment
Share on other sites

We've used our milenco levellers on our twin axle with our BPW diamond wheels locks without a problem. Put wheel lock(s) on then raise wheel(s) using the leveller(s).

 

Kate :)

Link to comment
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Guest
Reply to this topic...

×   Pasted as rich text.   Restore formatting

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

 Share

×
×
  • Create New...