Search the Community
Showing results for tags 'front panoramic window blind adjustment'.
1) Gently remove the two side LED light fittings these can be eased from behind the main light housing with your fingers and disconnect the light if it is in your way. This will show this, (Yours may be slightly different to this but same principle) and 2) Mark the cord with an indelible marker near to the screwed adjuster. 3) Then holding the loose end of the cord by either fingers or snipe nosed pliers (taking up the slack) loosen the securing nut sufficiently to allow the cord to be pulled through with ease, this should only be done in increments Max of 20mm (if there is that amount of give) tighten the nut back to the required amount to firmly hold the cord. Repeat this on the other side. 4) Check the blind can be pulled down and opened 5) Reconnect the LED lights (if you disconnected them) and replace light unit to panel again taking care not to apply too much force. HTH's KB